14
1-24: Each button has one or more alphabet characters assigned to it. Where two characters are assigned, the second
character is accessed by pressing twice.
PAGES: alternate between lower- and uppercase mode
F2 (SPACE): insert a blank space
F3 (LEFT): move the cursor 1 position to the left
F4 (RIGHT): move the cursor 1 position to the right
F5 (ESC): return to the device menu
F6 (ENTER): proceed to the next adjustment.
SLIDER 12: select numbered characters from ‘0’ to ‘9’
SLIDER 13: select lowercase characters from ‘a’ to ‘z’
SLIDER 14: select uppercase characters from ‘A’ to ‘Z’
Press F6 (ENTER) to proceed to setting up channels:
In the top line of the display the current channel number of the unit and the name of the current parameter are displayed. In
the bottom line the name of the current channel is displayed. If you have not assigned a name to it, the controller will name it
according to the slider number of the channel. The flashing caret indicates that a name may be created. Create the name of
the device’s channel according to the following instructions:
1-24: It can be read under the buttons which letter is written by the button to the display. Where two letters can be read
under it, there the back letter can be written by double pressing down
PAGES: changing lower- and uppercase mode
F2 (SPACE): write space character to the display
F3 (LEFT): Move the cursor to left position by 1
F4 (RIGHT): Move the cursor to right position by 1
F5 (ESC): leave making unit and back to unit directory
F6 (ENTER): go forward to the next adjustment.
SLIDER 12: select numbered characters from ‘0’ to ‘9’
SLIDER 13: select lowercase characters from ‘a’ to ‘z’
SLIDER 14: select uppercase characters from ‘A’ to ‘Z’
Press F6 (ENTER) to proceed to assigning sliders to actual channels:
Assigning the device channel to a slider:
In the top line of the display the current channel number of the device and the name of the current parameter are displayed.
In the present case SLIDER. Here the current channel can be assigned to a slider. In manual mode and when creating
programs the output value of this channel is set via the slider. In the bottom line of the display the assignment state of the
sliders can be seen. A horizontal line means that no channel is assigned to the slider with that number. The X means that a
channel has been assigned to that slider, but not the channel currently selected. The star means that the current channel is
assigned to the slider with that number. Where two stars are seen, a channel has been assigned to both possible slider states
(lower channel number/higher channel number). All 32 controllable channels may be accessed via the shift (SLIDER) button.
If it is flashing, then channels 17-32 are currently being accessed by the sliders.
If you do not wish to control a channel via a slider, it is not necessary to assign it to one. For example, a PAN or TILT
channel, or a channel not used by the device. A channel can be specified with the 1-16 sliders in the way that it is drawn to a
value higher than its half. Then a star will indicate the slider at the adequate place on the display.
Pressing the ENTER button you can move to the special settings.
Special setup of the unit channel:
