Instructions to assemble and install
Edition E0
Page 46 of 69
Confidential and Property of CoeLux S.r.l.
OPTION 2: if you intend to use the moon module [52] (PN 74-00064-01), unscrew the lid [53] and
take out the connector and the connected cables (take out a maximum of 10 cm of the cables).
Then, remove the moon module from its packaging, remove the male connector from the lid [53]
and use the two special screws to fasten it to the female connector on the moon module (pull
them as far as they will go). Now, remove the 4 M6 screws with washers [54] blocking the frame
[55] on to the projector [36B]. Place the moon module over the 4 holes [56] and reinsert the
entire cable inside the aperture on the projector. Use the 4 M6 screws with washers [54] to
fasten everything.
Use the centring pins [50] (red circle in Figure 46) to install the projector group on to the tilted
panel [29] (Figures 44 and 45). Fasten it with the 4 M6 captive screws [51] on the support plate
(Figure 46), which can be reached using the Phillips screwdriver with the 20 cm-long handle via
the through holes on the aluminium louvre.
N.B.: while you fasten the projector to the rest of the system, the three grey connection boxes
remain on your left (Figure 45).
Fig. 46
Installation sequence - Step 14B, OPTION 2
50
51
51
54
54
52
56
55
53
56