Instructions to assemble and install
Edition E0
Page 20 of 69
Confidential and Property of CoeLux S.r.l.
N.B.:
Open the boxes and clean the various
dark-box
components outside the clean chamber. If the
ceiling of the room is too high and the walls are too wide to fasten all 4 corners of the clean
chamber, use a gazebo as a support structure for the chamber walls.
If you have to assemble more than one piece of equipment, the polyethylene sheet structure
must be dismantled when you have completed assembling one box and recreated with new
sheets following the cleaning instruction procedure.
CLEANING THE COMPONENTS
All the components of the equipment must be cleaned immediately before their assembly.
All the optical parts must be handled with special care. Delicately remove any dirt so as not to
damage the optical surface and ensure the best performance.
We recommend you begin by cleaning gently and then proceed with more decisive, aggressive
cleaning to remove any contamination, if required.
CAUTION:
Incorrect cleaning could cause irreparable scratches on the optical surfaces.
If the surface is damaged, stop installation and contact CoeLux S.r.l to request a new replacement
part.
When assembly is complete, any visible dirt must be removed from all the internal, metal parts,
from the optical outlet and from the ventilation holes of the LED projector.
CLEANING THE MIRRORS AND THE COELUX® PANEL
CoeLux S.r.l. supplies the mirrors and the CoeLux® panel inside a specific packaging. When you
clean these parts, do not touch the surfaces with your fingers or with the sewn edge of your
gloves.
CAUTION:
You must always wear the cotton gloves provided in the cleaning kit to handle these surfaces.