Code Party 600, Руководство пользователя

Страница: 17 / 39

12 http://www.codelight.com
Please pay attention that if the fixture which is user added but not the Fixture Library, it won't give out
the concrete name of each channels;
Press S4 to exit.
3.5.2.2. Use Channel mode to change the Attributes
Select and turn on the fixtures as above;
Press soft-key Channel/Level and sw itch to "Live Mode-Channel" mode;
Fade in the relevant faders to complete different operation. If the fixture channel is more than 20, you
must work with soft-key 21/40 to complete setting 21-40 channels. If two kinds of fixture selected at the
same time, fader setting ineffectively because of the different channel attribute.
3.5.3. Using the Preset value
If there are some preset values have been saved in the Preset section. After selected and turned on the fixture,
you can press the button to add the needed channel va lues directly. (Such as brightness, colour, gobo and
Pan/Tilt position)
3.5.4. Run the Effect of the Fixtures
Please refer to the introduction in 5th chapter.
3.6. Manual Clear
Manually-controlled dimmer channels and fixtures can be cleared by pressing Clear, especially when you
editing Cue and Chase, you can quickly clear those unneeded effects.
3.7. Using Group
You can collect the same type fixtures into a Group, so that you can easily control them all together.
Example:
Set Unit button 1-10 of 2nd page as Group 1
Select Unit button 1-10 of 2nd page;
Press S3 [Group];
Roll Control Wheel B to make the present group No.=1 which shown on the LCD
Press S3 [Save Group].
Once you create the group, you can quickly select fixtures or dimmer channels.
Example:
Select group 1
In the Live mode, press S3 and select [Group];
Use Control Wheel B and roll the No.=1;
Press S1 [Load Group], then Units 1-10 of 2nd page are selected.