Cocoon HE150272, Инструкция по эксплуатации

Страница: 38 / 60

38
After Sales Support
1300 663 907
Model Number
HE150272
customercare@winplus.com.au
Using Cura
SUPPORT
Support Type
Some models will require support material in order to print properly. This will usually occur when
an object has an angle in relation to the Heated Print Bede between 0 to 45 degrees. It is highly
recommended to orient your object so that it minimizes or eliminates the need for support.
Touching Buildplate
This causes the support material to build up between the Heated Print Bed and the object.
The red example is ‘Touching Buildplate’
Everywhere
This prints support material between the Heated Print Bed and object as well as between the
object and itself. The green example is ‘Support Everywhere’.
Platform Adhesion Type
Some models have a small surface area contacting the plate. This can create adhesion issues
causing your part to pop off at some point during the print. To fix this, use either ‘Brim’ or ‘Raft’.
Raft is better used when a model has small contact points with the Heated Print Bed and
overhangs.
Brim
Brim will create a single layer of filament, contacting and surrounding your model. This will
increase the surface area of the part contacting the build platform thereby preventing it
from popping off the Heated Print Bed. Brim will also help in situations where you are seeing
corner lift.
Brim settings can be adjusted by selecting ‘...’ next to the tab.
Raft
Raft will generate a layer of material underneath your object. Raft was more often used
before the addition of heated plates to increase surface area. Raft settings can be adjusted
by selecting ‘...’ next to the tab.
.