Cocoon HE150272, Инструкция по эксплуатации

Страница: 15 / 60

15
After Sales Support
1300 663 907
Model Number
HE150272
customercare@winplus.com.au
Quick Guide
10. Wait for the printer to initialise, with Printer Ready shown at the bottom of the LCD. Press the
Navigation Dial to enter the menu system. Rotate the Dial until Position is highlighted, then
press the Dial to select. Rotate the Dial until Z. Pos. Fast is highlighted, then press to select.
Rotate the Dial clockwise, raising the Extruder so that you can easily access the Heated Print
Bed. Turn off your 3D Printer
Levelling the Bed
1. Squeeze each corner of the printing bed, and tighten each wing nut to reduce the distance
between plates to a minimum. Wipe the top of the Heated Print Bed with a clean, lint-free
cloth to ensure no dust particles or other objects are on the Heated Print Bed. Remove all the
white tape covering the X, Y, Z axis stop micro switch prior to the next step
2. Using the switch on the back of the Control Box, turn on the Cocoon Create 3D Printer.
Once initialised, press the Navigation Dial to enter the menu system. Navigate to and select
Position then select Home All. Your 3D printer will now try to align to the home position, on
the front left corner of the Heated Print Bed. Once aligned, turn off the 3D printer
NOTE:
Immediately turn off the machine if any of the motors are jamming or forcing against the
chassis
3. With the printer powered off, check the Z axis level. The X rail should be parallel to the Heated
Print Bed. If it is not, manually rotate the right hand side Z axis stepper motor to level it
4. Manually move the Extruder to one corner of the Heated Print Bed to check the distance
between the nozzle and Heated Print Bed. Rotate the wing nut to raise the Heated Print Bed.
The distance between the Extruder and bed should be 0.1mm or roughly the thickness of
an A4 sheet of paper. The paper should have very slight friction as you move it under the
Extruder but should still slide freely
5. Move the Extruder to each of the other corners and repeat the process. Move the Extruder to
the centre of the Heated Print Bed and test the gap with a sheet of paper. Keep adjusting and
testing until the gap is uniform on all points of the bed
IMPORTANT NOTE: Levelling the bed is an extremely important step and if it is not done
correctly every time, your prints will fail or be of poor quality
.