Cochran Nemesis IIa NITROX, Руководство пользователя

Страница: 58 / 79

58
11. For the depth benchmark programming, the WU display a lower case d. This
depth benchmark is set in 1-foot increment down to a maximum of 30 feet. First,
you will program the 10's digit (d-2) followed by the 1's digit (d-1)
12. Next, you will program the cylinder size you are using in liters. During this
programming step, the WU upper left corner will display an L. Whole liters up
to 255 are allowed. The formula to calculate liters is:
Cylinder Size (cu.ft.) divided by Working Pressure (psi) multiplied by 411 = Liters
For example, an 80 cu.ft. cylinder rated at 3000 psi would be calculated as follows:
80
3000
X 411 = Liters 0.0266666 X 411 = 10.959972 Liters
This would be rounded to 11 Liters.
13. Next, using the same sequence of SELECT and INCREMENT, you will
enter a desired percentage of added conservatism from 00 to 50 percent.
This option programming is signified with a C in the upper left corner of the
WU display.
14. The last programming option is the maximum depth alarm. This program-
ming is signified with an A in the upper left of the WU display. This alarm
is set in one foot increments from 10 to 326 feet. You will first program the
100's digit (A-3) than the 10's digit (A-2) and finally the 1's digit (A-1).
Once you have completed programming, press the SELECT button to review all of your
desired settings. You must review the entire programming cycle without making any
changes before the TU will automatically exit the programming mode. If you remove the
data probe before the TU has automatically exited the programming mode, the setting
you have programmed WILL NOT be saved. Only after reviewing ALL of the possible
programming fields will the TU save the programming and automatically exit the
programming mode.