Coby DVD938, Инструкция по эксплуатации

Страница: 55 / 180

Page 54 Coby Electronics Corporation www.cobyusa.com Page 55
En
gl
ish
Safety Notices
Power Sources: This product should be operated only from the type of 10.
power source indicated on the rating label. If you are not sure of the type
of power supply to your home, consult your product dealer or local power
company. For products intended to operate from battery power or other
sources, refer to the operating instructions.
Grounding or Polarization: This product may be equipped with a polar- 11.
ized alternating-current line plug that has one blade wider than the other.
This plug will only fit into the power outlet in one direction. This is a safety
feature. If you are unable to insert the plug fully into the outlet, try re-
versing the direction of the plug. If the plug should still fail to fit, contact
an electrician to replace the obsolete outlet. Do not defeat the safety
purpose of the polarized plug.
Power-Cord Protection: Power supply cords should be routed so that 12.
they are not likely to be walked on or pinched by items placed upon or
against them, paying particular attention to cords at plugs, convenience
receptacles, and at the point which they exit from the product.
Protective Attachment Plug: The product may be equipped with an at- 13.
tachment plug with overload protection. This is a safety feature. See the
operating instructions for replacement or directions to reset the protective
device. If replacement of the plug is required, be sure the service techni-
cian has used a replacement plug that has the same overload protection
as the original plug as specified by the
manufacturer.
Outdoor Antenna Ground- 14.
ing: If an outside antenna is
connected to the product,
be sure the antenna sys-
tem is grounded so as to
provide some protection
against voltage surges
and built-up static charges.
Article 810 of the National
Electrical Code, ANS/NFPA 70
provides information with regard to
proper grounding of the mast and supporting structure, grounding of the
lead-in wire to an antenna-discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to grounding electrodes,
and requirements for the grounding electrode (see figure).