COBHAM Sea Tel Dual Antenna Arbitrator, Руководство по установке

Страница: 29 / 41

Slide Rail Kit (optional) Installation Dual Antenna Arbitrator (MXP)
8-1
8. Slide Rail Kit (optional) Installation
If you have purchased the optional slide rail kit, follow the instructions below to install the slide rails.
Refer to drawing 135681 in the drawing section of this manual.
8.1. Assembling the Outer Rails
Refer to drawing 135681 Detail A to assemble the outer rails for the inside of the rack.
1. Attach the Mounting brackets to the rack rails using the hardware provided. Do not tighten the hardware
at this time.
2. Adjust the mounting brackets to the correct length for the rack that they will be installed in (test fit in the
rack is highly recommended).
3. Apply Loctite 242 to and tighten the mounting bracket hardware.
8.2. Mounting the Outer Rails In the Rack
Refer to drawing 135681 Detail C to install the outer rails into your equipment rack. Refer to detail C1, C2 or C3 as
is appropriate for the vertical rails in your equipment rack.
1. Attach the Mounting brackets to the vertical rack rails using the appropriate hardware (provided per detail
C1, C2 or C3 as is appropriate for the type of vertical rails in your equipment rack).
2. Tighten the mounting bracket hardware.
8.3. Mounting the Inner Rails
Refer to drawing 135681 Detail B to assemble the outer rails for the inside of the rack.
1. Attach the inner rails to the body of the Arbitrator using the hardware provided.
2. Apply Loctite 242 to and tighten the mounting hardware.
8.4. Mounting the Arbitrator Into Your Rack
Refer to drawing 135681 Detail D to install the Arbitrator into your equipment rack.
1. Slide the inner rails mounted to the Arbitrator into the outer rails mounted in the equipment rack.
2. Route and connect the cables to the rear of the Arbitrator, assuring that you have sufficient cable length
to allow the Arbitrator to be fully extended out on its slides without chaffing or tearing the cables.
3. Push the Arbitrator fully into the rack.
4. Install the 4 retaining screws through the front panel of the Arbitrator into the vertical rails and tighten.