COBHAM Sea Tel Dual Antenna Arbitrator, Руководство по установке

Страница: 15 / 41

Remote Operation Dual Antenna Arbitrator (MXP)
3-5
show antenna {a | b} ip
The show antenna A/B ip command displays the current IP addresses set for the two DACs.
Parameters:
a: shows DAC A’s IP address in dot-decimal format
b: shows DAC B’s IP address in dot-decimal format
show antenna source
The show antenna source command displays the current active antenna.
show hot_standby
The show hot_standby command displays the current status of the 10MHz oscillator.
show gps source
The show gps source command displays the current source of GPS data.
upgrade system serial
The upgrade system serial command upgrades the software version using the serial downloader.
help
The help command provides the user with additional information about the command structure in
relation to what has been entered at the command prompt by the user.
save
The save command stores the current Arbitrator parameters.
Note: upon hardware or software reset, the Arbitrator will load the parameters from the last save point or
the default parameters if a save point has not yet been created.
{quit | exit}
The quit or exit commands closes the Telnet session.
Note: this command is not valid for the serial interface.
logout
The logout command returns the user to the login screen of the Telnet interface.
Note: this command is not valid for the serial interface.
Reset
The reset command forces the Arbitrator to perform a software reset.
Note: any unsaved parameter changes will be lost upon hardware or software reset.
3.3.2. General Notes
Unless otherwise noted, the cr (0x0D), lf (0x0A), “>" echo indicates that the Arbitrator has accepted a
command and is ready to process the next command. Any additional commands will not be accepted
until after the Arbitrator echoes cr (0x0D), lf, “>".
All commands are case independent such that commands can be entered as all capital
letters, all lower case, or a random mix for a valid command.
All commands should be followed by cr (0x0D) in order to be received and processed. This
was intentionally omitted above for ease of readability.
Additional characters added after a valid command are not ignored and will return a user error message.
After a valid command, “ ‘ “ (0x27) can be used to add comments or other characters to be ignored by
the Arbitrator.