COBHAM Sea Tel Dual Antenna Arbitrator, Руководство по установке

Страница: 13 / 41

Remote Operation Dual Antenna Arbitrator (MXP)
3-3
sss ASCII string of characters.
lf (0x0A) or \n Line Feed (New Line)
↵
, cr (0x0D) or \r
Carriage Return (Enter)
3.3.1.
Command Details
set system default
The set system default command changes all of the Arbitrator’s configurable parameters to their default
values specified in Appendix B.
Note: This command choice will be confirmed by user with a prompt with arguments of {yes / no}. yes
will confirm setting system parameters to default values; no will confirm ignoring of set system default
command.
set system network {gateway / netmask / ip} nnn.nnn.nnn.nnn
The set system network command changes the values for the Arbitrator IP address, netmask, and
network gateway. Parameters:
gateway: changes the Arbitrator network gateway to value specified
netmask: changes the Arbitrator netmask to value specified
ip: changes the Arbitrator ip address to value specified
nnn.nnn.nnn.nnn: argument specified in standard dot-decimal notation
Note: these changes will not be implemented until after a hardware or software reset. Note: the
Arbitrator only supports IPv4
set system mode {manual / auto}
The set system mode command changes the Arbitrator switching mode. Parameters:
manual: the active antenna is user selectable and will not switch based on antenna state
auto: the active antenna is not user selectable and will switch automatically based on antenna
state
set system forward port nnnnn
The system forward port command changes the TCP port on which packets will be forwarded to and
from the satellite modem to the DACs. Parameters:
nnnnn: This is the decimal value of the port number between 0-65535 inclusive.
set system {username | password} sssssssss
The set system username/password command changes the default username/password. Parameters:
username: change the default username
password: change the default password
sssssssss: the new username string
Note: the username/password must be alphanumeric and no longer than 9 characters. Note: the user will
be prompted to confirm the username/password selection. To confirm, retype the username/password
as entered in the command above. Any other input will force the username/password change to be
ignored.
set antenna {a / b} ip nnn.nnn.nnn.nnn
The
set
antenna A/B ip command changes the IP addresses that correspond to ANT A/B DACs, use.
Parameters:
a: the IP entered corresponds to ANT A’s DAC
b: the IP entered corresponds to ANT B’s DAC
nnn.nnn.nnn.nnn: IP address specified in standard dot-decimal notation
Note: the Arbitrator only supports IPv4