COBHAM Sea Tel Dual Antenna Arbitrator, Руководство по установке

Страница: 12 / 41

Dual Antenna Arbitrator (MXP) Remote Operation
3-2
3.2.2. Interface requirements:
3.2.2.1. Hardware
Sea Tel Antenna Control Units Model DAC-2202 or DAC-2302.
Any Satellite modem manufacturer that is compatible with OpenAMIP
TM
CAT5 Patch cable
3.2.2.2. Software
Sea Tel model DAC-2202:
ACU software version 6.06 or greater
CommIF module software version 1.10f or greater
Sea Tel model DAC-2302:
ACU software version 7.06 or greater
CommIF module software version 1.10f or greater
3.3. Dual Antenna Arbitrator Command Summary
Use the following commands to communicate directly with the Dual Antenna Arbitrator:
COMMAND FUNCTION
set system default Set all Arbitrator parameters to default
set system network {gateway|netmask|ip}
nnn.nnn.nnn.nnn
Set network address values
set system mode {manual|auto} Set Arbitrator switching mode
set system forward port nnnnn Set TCP forwarding port between DACs and modem
set system {username|password} Change default username or password
set antenna {a|b} ip nnn.nnn.nnn.nnn Set DAC A/B IP address
set antenna {a|b} active Set which antenna is currently active
set hot_standby {on|off} Turn 10MHz Reference for hot standby on/off
set gps source obm Set GPS source to OBM or none
set gps source antenna {a|b|active} Set GPS source to either antenna a/b/whichever is active
show all Show all system parameters
show system network {gateway|netmask|ip} Show the current network gateway, netmask, or IP
address
show system mode Show whether the Arbitrator is in auto or manual mode
show system forward port Show which TCP port links the DACs and modem
show system version Show the current loaded Arbitrator software version
show antenna {a|b} ip Show the IP address of DAC A/B
show antenna source Show which antenna is used in the current RF path
show hot_standby Show whether the hot standby reference is on/off
show gps source Show the current source of GPS data
upgrade system serial Update the Arbitrator software via the serial port
help Show possible command options
save Save the current parameters settings
{quit|exit} End the Telnet session
logout Return to the Telnet session login screen
reset Reboot the Arbitrator via software reset
ABBREVIATIONS:
aaaa ASCII number of degrees in tenths.
xxxx ASCII hex I/O data 0000 – FFFF range
nnnnn ASCII decimal number (0000 - 99999)
nnnn ASCII decimal number (0000 - 9999)
nnn ASCII decimal number (0 - 255)