COBHAM Sea Tel Dual Antenna Arbitrator, Руководство по установке

Страница: 14 / 41

Dual Antenna Arbitrator (MXP) Remote Operation
3-4
set antenna {a | b} active
The set antenna A/B active command changes which antenna is currently active. Parameters:
a: ANT A is active
b: ANT B is active
Note:
this
will temporarily override the current active antenna regardless of switching mode. If the
Arbitrator is in auto mode and the system state is such that the antenna not selected should be active,
the Arbitrator will switch back to that antenna almost immediately.
set hot_standby {on / off}
The
set hot standby command turns the 10MHz reference on or off. Parameters:
on: 10MHz oscillator will be enabled
off: 10MHz oscillator will be disabled
Note
: Regardless of whether or not the connector is accessible on the back panel, this command will still
configure the reference oscillator. For customers without the 10MHz Reference connector, it is
recommended the hot_standby be turned off.
set gps source obm
The
set gps source obm command changes the GPS source to be either the Out of Band Manger
connected to the Arbitrator or have the GPS taken from a source that is not either antenna’s DAC.
set gps source antenna {a / b / active}
The
set gps source antenna command changes the GPS source to be one of the antenna’s DACs.
Parameters:
a: always take the GPS data from ANT A DAC
b: always take the GPS data from ANT B DAC
active: GPS data source will switch automatically along with RF path
show all
The
show all command displays all of the Arbitrator’s current settings.
Note:
the
output of this command is structured such that it can be issued back into the Arbitrator to
restore its previous state.
show system network {gateway | netmask | ip}
The
show
system network command displays the Arbitrator network settings. Parameters:
gateway: displays the network gateway address in dot-decimal notation
netmask: displays the netmask in dot-decimal notation
ip: displays the Arbitrator IP address in dot-decimal notation
show system mode
The
show
system mode command displays the current Arbitrator switching mode.
show system forward port
The show system forward port command displays the current TCP forwarding port between the modem
and the DACs.
show system version
The show system version command displays the current Arbitrator software version.