COBHAM S-TEC Thirty, Руководство по эксплуатации для пилотов

Страница: 50 / 88

3rd Ed. Feb 15, 07 2-33
S–TEC
ACTION RESPONSE
35. Disconnect autopilot by any one
of the following means:
a. Press optional AP DISC Switch
typically located on Control Wheel.
b. Press/Hold optional MODE SEL
Switch typically located on Control
Wheel for 3 seconds.
c. Press/Hold PUSH MODE Switch
located on bezel for 3 seconds. RDY lamp flashes and audible alert
sounds a periodic tone, while all other
lamps are extinguished.
After 5 seconds, RDY lamp stops
flashing but remains illuminated, and
audible alert is squelched.
36. Move A/C Control Wheel left and
right. A/C Control Wheel’s increased
freedom of movement indicates that
Roll Servo is disengaged.
37. Move A/C Control Wheel forward
and aft. A/C Control Wheel’s increased
freedom of movement indicates that
Pitch Servo is disengaged.
Note: If a Yaw Damper is installed, then proceed to step 38. Otherwise,
proceed to step 47.
38. Actuate A/C Rudder Pedals
alternately in succession, to sense
their freedom of movement about yaw
axis. ------
39. Set Yaw Damper Master Switch
to ON position. ------
40. Turn Yaw Trim Knob until A/C
Rudder Pedals stop. ------
Table 2-5. Pre-Flight Test, System Thirty (continued from page 2-30)