COBHAM explorer 727, Руководство пользователя, Страница: 51 / 179

Chapter 3: To operate the system
98-126882-F To use a computer 44
To use PPPoE (Point-to-Point Protocol over Ethernet)
Overview
You can establish a PPPoE connection to the BGAN network using the EXPLORER system. Use
PPPoE if you want to control your connection independently of the web interface and the IP
Handset.
Possible applications are:
• Connect a router
• Connect broadcast equipment, optionally through a PC
• Establish a Picocell for the use of cell phones
The following drawing shows connections managed through PPPoE and web interface
respectively.
To configure the connected equipment for PPPoE
To use PPPoE with your EXPLORER system, first enable PPPoE in your terminal. Refer to
To
enable PPPoE (Point-to-Point Protocol over Ethernet) on page 71.
After you have enabled PPPoE in the terminal, you must configure your equipment.
How to do this depends on the type of equipment. Refer to the user documentation of the
equipment. As a minimum, you need to configure the following parameters in your equipment
in order to make PPPoE work with the terminal:
• User name and password.
The user name and password can be left blank (or insert user name:
void and password:
void
). Then the registration on the Access Point is most commonly done in such a way
that the data connection is established with a dynamic IP address from the airtime
provider.
BGAN terminal
PDP Context, up to 11
BGAN
nework
Built-in
web
interface
PPPoE
connection
PC and/or broadcast equipment
User PC 1
Applications
for PPPoE
Handling connection
to the BGAN terminal
Assigning connection
(PDP context) to go out
on the BGAN network
Router
Pico cell
PPPoE
connection
User PC 2
PPPoE
connection
IP
Handset