COBHAM explorer 727, Руководство пользователя, Страница: 78 / 179

Chapter 4: To use the web interface
98-126882-F To set up the interfaces 71
To enable PPPoE (Point-to-Point Protocol over Ethernet)
What is PPPoE
By using PPPoE, users can virtually “dial” from one machine to another over an Ethernet
network, establish a point to point connection between them and then securely transport data
packets over the connection.
On the equipment connected to the EXPLORER 727 Terminal you must enter a few settings for
your PPPoE connection. For example you need to set up which service to use (e.g. 64 kbps
Streaming) and possibly a user name and password. For details, refer to
To use PPPoE (Point-
to-Point Protocol over Ethernet) on page 44 and to the documentation for your connected
equipment.
On the EXPLORER 727 Terminal you must enable PPPoE before you can establish a PPPoE
connection. Refer to the next section.
To enable PPPoE in the EXPLORER 727 Terminal
To enable PPPoE in the terminal do as follows:
1. Select
SETTINGS > LAN > PPPoE
.
2. Select
Enabled
.
3. Select the
APN
to use for PPPoE. You have the following options:
•
SIM default
. The APN is taken from the SIM card. This is the recommended option,
unless you have special requirements.
• Network assigned . The APN is assigned from the network.
•
User defined
. Type in the APN. APNs are provided from the Airtime Provider.
4. Click Apply .
5. Restart the terminal for the setting to take effect.
For information on how to establish a connection with PPPoE, see To use PPPoE (Point-to-
Point Protocol over Ethernet) on page 44.