3
DECrepeater 90TS Installation and Configuration
Front Panel
1) Power
LED — Lights when the module
has power.
2) Module OK
LED — Lights when the
module passes self-test. If the module fails
self-test, the Module OK
LED remains off.
3) Network OK
A LED — Indicates the
status of the ThinWire, 10Base2 port.
4) Network Activity
LED — Indicates
network traffic level.
5) Network OK
B LED — Indicates the status
of the AUI port.
6) Port State LEDs (1 through 8) — Show the
status of the eight ports. The port LED is on
when that port has a valid port connection, is off
when there is no port connection, and is
flashing when the port connection is disabled
by network management.
NOTE:
For more information about LED
operation, refer to the section
titled LED Descriptions.
7) 10BaseT (8-pin MJ) port connectors
(1 through 8) — Connectors for ports 1 to 8.
Support both UTP and STP cabling.
8) Serial port (8-pin MJ) connector —
Multiplexed port can be used as a setup port or
for OBM.
9) ThinWire port connector — Connects
through a BNC T-connector when the module
is operating as a standalone unit.
10) Ethernet address label — Shows the
Ethernet address for the module.
LKG-9142-94I
5
6
7
Side view
9
10
2
4
1
3
8
