cPad – MP Configuration Manual
Documentation Revisionv1.07
4
cPad Configuration for Connection to My Prints
Requirements
This document is related to a
My Prints
cPad firmware version V1.7.1 or greater
connected to a My Prints Release version 1.1.
Before you start you will need to ensure you have;
•
The correct number of licences for the
My Prints
cPads.
•
If installing on a third party MFD you must have permission from the
owner of the MFD before proceeding.
•
The correct interface cables properly connected.
•
The correct EPSV kit and firmware settings installed on your Xerox
MFDs.
If you are unsure about any of the terminology or processes outlined in this
manual please contact ‘My Prints’ support before proceeding further.
What’s in the box
The
My Prints
cPad box contains;
•
Quick setup guide
•
MyPrints
cPad
•
Power Supply (24VDC 1A) Standard supply is Australian, if you require
a foreign power supply, please ensure you supply information at time of
order.
•
EPSV interface cable – (provided it was included on the order)
•
Network Interface cable – Catergory 5e crossover
The box may also contain other items if these are specifically requested for
special reasons.
