CME TOPTEL 2-200, Инструкции и коды

Страница: 9 / 40

7
FITTING THE BATTERIES
Fit the batteries and programme
the remote control before using it.
The remote control requires 2 new 1.5V
AAA/LR03
alkaline batteries. Insert the batteries as shown:
• Replace the batteries if the indicator light on the remote control starts to fl ash
during use. The batteries are low.
•
Make a note of the codes for your appliances on the adhesive label inside the
battery cover in case you have to reprogramme your remote control.
• This remote control has a permanent memory and does not lose the programmed
codes or functions even when the batteries are removed.
HOW TO PROGRAMME THE REMOTE CONTROL
1. Switch ON the appliance you wish to programme and select
a programme.
2. Look for the brand of the appliance you want to programme
in the code list and make a note of the corresponding code
alongside (e.g. PHILIPS 0025) . Notice: if the brand is not
on the list, you can perform the programming procedure
using the replacement code 0099 .
3. Hold down the selection button for the appliance to be
programmed for 5 seconds.
4. When the button is released, it will start to fl ash. Enter the
previously identi fi ed brand code (e.g. 0025) . The selection
button fl ashes more quickly, indicating that the remote
control is ready for the search.
5.
Point the remote control at the appliance. Press and slowly
release the ON/OFF button several times, stopping when the
appliance goes off.
6. When the appliance goes off, press the OK button to con fi rm.
Three fl ashes indicate that the search operation has been
completed correctly.
ADDITIONAL CHECK
Check that some of the other buttons, corresponding to those on your original remote control, work correctly. If
the commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 3 , entering the previously used
code (e.g. 0025).
To display and make a note of the code memorized by means of the search,
follow the instructions described in the CURRENT CODE DISPLAY paragraph.
The quickest and easiest way to programme the remote control
is by consulting the website www.cme.it .
Warning: programme one appliance at a time!
WARNING: do not expose the remote control to sources of excessive heat
The TV - SAT - TER buttons can be programmed according to your requirements,
Following the procedure described below.
PHILIPS 0025
5 SEC.
or or