CME TOPTEL 2-200, Инструкции и коды

Страница: 11 / 40

9
CURRENT CODE DISPLAY
1. Press the selection button for which you want to know the
code and hold down for 5 seconds.
2. When the button is released it will start to fl ash; press and
release the 1-/-- button within 8 seconds .
3. After a pause of a few seconds, the indicator light
produces four series of fl ashes with a space between them,
corresponding to the code you are looking for. Count the
number of fl ashes; each series of fl ashes corresponds to one
fi gure in the code.
10 fl ashes correspond to 0
.
4. Write this code on the adhesive label on the inside of the
battery cover for quick and easy future reprogramming.
To fi nd out the code of your remote control, follow this procedure:
5 SEC.
Code obtained = 1306
NOTE: this operation cannot be interrupted and the remote control
therefore cannot be used until the end of the four series of fl ashes.
ENTERING THE CODE
If, by consulting the on-line guide, you have found the exact code of the appliance with which to programme the
remote control, enter it as follows:
1. Press and hold for 5 seconds the selection button for the
appliance for which you want to enter the code.
2. When the button is released it will start to fl ash; enter the
code (e.g. TV 1306). Three fl ashes indicate that the
operation has been completed correctly.
HOW TO USE THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
Although not indicated on the keypad,
some buttons can be used for additional commands.
Search for them on your remote control by pressing the buttons one after the other to fi nd any other commands that
might be of interest to you.
In particular, the additional functions most frequently used, such as NORMALIZATION , COLOUR and BRIGHTNESS ,
can be found on the following buttons
Normalization:
For the functions used less frequently, look for the additional commands on the site www.cme.it . Consult the
on-line guide not only to easily fi nd the code needed to programme your remote control, but also to help you fi nd
which buttons on the remote control correspond to the additional commands.
Brightness (+):
Brightness (–):
Colour (+):
Colour (–):
or
or
or
or
ALWAYS ACTIVE TV FUNCTIONS
The following TV functions are available on the 4 central buttons of the remote control: ON/OFF, VOL-, VOL+ and AV .
These functions can be used to control appliances other than the TV. This makes controlling the digital terrestrial
decoder combined with a TV easier since you no longer need to change the remote control in order to use the audio
functions.
WARNINGS: in rare cases, instead of pressing the TV ON/OFF button to turn ON the TV, you may need to select the TV
button in the upper left and then press any one of the number buttons.
or or
5 SEC. or or