CME TOPTEL 2-200, Инструкции и коды

Страница: 10 / 40

8
1. Switch ON the appliance you wish to programme and select
a programme.
2. Hold down the selection button for the appliance to be
programmed for 5 seconds.
3.
When the button is released, it will start to fl ash. Enter the
code 0000 ; the selection button fl ashes more quickly to
indicate that the remote control is ready for the search.
4. Point the remote control at the appliance. Press and slowly
release the ON/OFF button several times, stopping when
the appliance goes off.
5. When the appliance goes off, press the OK button to con fi rm.
Three fl ashes indicate that the search operation has been
completed correctly.
NOTE: THE INDICATOR LIGHT STOPS FLASHING.
The remote control exits the programming mode and the indicator light stops fl ashing:
• if no buttons are pressed for 14 seconds
• if an invalid brand code is entered
• if a button other than ON/OFF is accidentally pressed
• if the end of the code search list has been reached. In this case, consult the website www.cme.it
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
This operation can take up to 20 minutes and should be carried out if you were
not successful in programming the remote control by means of the method described above.
The quickest and easiest way to programme the remote control
is by consulting the website www.cme.it .
Warning: programme one appliance at a time!
ADDITIONAL CHECK
Check that some of the other buttons, corresponding to those on your original remote control, work correctly. If
the commands function incorrectly or erratically, you have probably entered a code for a similar remote control but
not the right one. In this case, repeat the search procedure starting from
point 2 .
To display and make a note of the code memorized by means of the search,
follow the instructions described in the CURRENT CODE DISPLAY paragraph.
NOTE: THE INDICATOR LIGHT STOPS FLASHING.
The remote control exits the programming mode and the indicator light stops fl ashing:
• if no buttons are pressed for 14 seconds
• if a button other than ON/OFF is accidentally pressed
• if the end of the code search list has been reached. In this case, consult the website www.cme.it
5 SEC. or or