65
english
ENGLISH
11. Making coffee
11.1
SMSA
version
The programming of every dose must be done with ground coffee
and not with previously used grounds.
i
Dispensing
coffee
COFFEE DOSE PROGRAMMING
• Turn the programming key (
8) to the ON position;
• put the coffee cup under the dispensing spout;
•
Hold the
key down for 5 seconds: all LED on the push button panel
come on;
•
Press the dose key to be programmed (e.g. 1 espresso coffee
) ;
•
Wait for dispensing. To confirm the dose press the dose key
or the
key again .
•
Repeat this operation for the other dose keys.
•
Upon conclusion of the programme, press the key
until all LEDs go
off on the push button panel, and turn the programming key to OFF.
For models with 2-3-4 groups it is possible to program simultaneously all ma-
chine push button panels using only the right push button panel. It is however
advisable to check the programming of the other push button panels.
11.2
SME
version
COFFEE DELIVERY
• put the coffee cup under the dispensing spout;
• press the desired dose key and wait for coffee to be delivered
(LED comes
on);
•
to stop delivery of coffee in advance, press the delivery key again or press
the key
;
•
in the event of anomalies or if the push button panel is locked, use the manual
delivery switch.
•
put the coffee cup under the dispensing spout;
•
Press the desired delivery switch. You will have the delivery which can be
stopped by means of the same switch once the desired amount of coffee in
the cup is obtained.
MA
RIS
A
8
