closomat Asana, Руководство по эксплуатации

Страница: 21 / 32

21
13.2 WARM AIR NOZZLE
WARNING
Under no circumstances
activate flushing the WC when
the warm air nozzle is open or
has been removed! No liquid
must be allowed to enter the
opening for the warm air
nozzle.
If the warm air nozzle fails to
return to its normal storage
position even after initialisation
(switch unit on and off again after
30 seconds), it must under no
circumstances be pushed back in
manually. Please call our service
department on 0800 374 076.
The inside of the warm air nozzle stays clean due to its enclosed storage
position. Care must be taken to ensure that the warm air function is
always switched off during normal use. If the air nozzle has to be
removed for cleaning purposes, please follow the instructions below:
After the shower nozzle has been cleaned (as described above in 13.1 ),
the warm air nozzle opens automatically and remains in this position for
10 minutes. Gripping the nozzle head, twist gently in anti-clockwise
direction and carefully pull out (Photos 1 to 3). To replace the nozzle
head, push in gently with the blower opening facing upwards, twist in a
clockwise direction and engage until it clicks in position (Photos 4 to 6).
It is possible to cause the warm air nozzle to retract early by pressing
the two front push-buttons left and right simultaneously and holding
down for at least 2 seconds.
WARNING
If the seat and lid have been
removed, make sure that no
liquid can enter the holes for
the hinges!
Do not use any abrasive
cleaning agents, abrasive
sponges or cloths for cleaning!
Do not under any
circumstances use cleaning
agents containing chlorine,
such as bleach!
If the time elapsed between removing and inserting the nozzle is longer
than 10 minutes, the support returns to its storage position (where it is
invisible). The air nozzle cannot be inserted in this position until the two
front push-buttons have again been pressed and held down for at least
2 seconds. When the shower nozzle extends, simultaneously press both
push-buttons again and the shower nozzle will retract and the support
will push forwards (this cannot be seen). Insert warm air nozzle again,
press both push-buttons and the air nozzle will retract. The nozzle must
always be fully enclosed in its storage position.
21