Cloos GLW 322, Инструкция по эксплуатации и запасные части

Страница: 29 / 39

Cod.006.0001.1861
01/09/2014 v2.0
ENGLISH
GLW 322
28/38
4.6 PARAMETERS SETTING: (2ND LEVEL)
S2 Press this button to scroll the list of settings to edit.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1 Using the encoder, edit the value of the selected setting.
The value is saved automatically.
Press any key (except S2) to save the setting and quit the menu.
Tab. 9 - Parameters of the 2nd level menu: MMA mode
ACRONYM PARAMETER MIN DEFAULT MAX
Urd OUTPUT VOLTAGE REDUCTION oFF oFF on
U.EL. LONG ARC VOLTAGE 37 47 65
rC REMOTE CONTROLLER ACTIVATION oFF oFF on *1
S2 Hold down the button for 3 seconds to gain access to the 2nd level menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
S2 Press this button to scroll the list of settings to edit.
E1 Using the encoder, edit the value of the selected setting.
The value is saved automatically.
Press any key (except S2) to save the setting and quit the menu.
Tab. 10 - Parameters of the 2nd level menu: CONTINUOUS DC TIG mode, PULSED DC TIG mode, SYNERGIC DC TIG mode
ACRONYM PARAMETER MIN DEFAULT MAX
SP.t. SPOT TIG TIME 0.01 s 0.01 s 10.0 s
HF HF ARC STRIKE ENABLE on on oFF
rC REMOTE CONTROL ACTIVATION on oFF on *2
r.P.C. MINIMUM PEDAL CURRENT 1 % 5 % 90 %
Tab. 11 - 2nd level menu parameters in AC TIG mode
ACRONYM PARAMETER MIN DEFAULT MAX
AC AC WAVEFORM 1 1 9
VALUE DC+ WAVEFORM DC-
1 sine sine
2 rectangular rectangular
3 triangular triangular
4 sine rectangular
5 rectangular sine
6 sine triangular
7 triangular sine
8 rectangular triangular
9 triangular rectangular
SP.t. SPOT TIG TIME 0.01 s 0.1 s 10.0 s
HF HF ARC STRIKE ENABLE on on oFF
rC REMOTE CONTROL ACTIVATION on oFF on *2
r.P.C. MINIMUM PEDAL CURRENT 1 % 5 % 90 %
*1: Remote control types:
- manual remote controller.
*2: Remote control types:
- UP/DOWN or potentiometer TIG torch.
- foot pedal controller.
The maximum and minimum TIG welding current values can be set with the foot pedal controller.
The up slope and down slope cannot be controlled via the foot pedal.
The following welding procedures can be selected with the foot pedal:
2T LIFT ARC - 2T HF - 2T SPOT - 2T SPOT HF