Cloos GLW 322, Инструкция по эксплуатации и запасные части

Страница: 25 / 39

Cod.006.0001.1861
01/09/2014 v2.0
ENGLISH
GLW 322
24/38
4.4 PARAMETERS ACTIVATION
The welding parameters are available in accordance with the selected welding mode and procedure.
Certain parameters are available only after other parameters or functions of the unit have been enabled or set.
The table shows the settings required to enable each parameter.
KEY

:
Always available.
1:
Available when remote control is disabled.
2:
Available when remote control is enabled and a remote control pedal is connected to the unit.
3:
Available with the following setting:
HF ARC START = ON
4:
Available with the following setting:
MULTI TACK = OFF
5:
Available with the following setting:
TYPE OF PULSED CURRENT = SLO.
6:
Available with the following setting:
TYPE OF PULSED CURRENT = FA.
Meaning of symbols
1+2=
All conditions must be fulfilled (both 1 and 2).
MENU MODE 
 PROCEDURE 
PARAMETER 
1° WELDING CURRENT 1 1 1 1 1 1 1 1 1 1 1 1 1
1°
MAXIMUM CURRENT WITH REMOTE
CONTROLLER
2 2 2 2 2 2 2
1° HOT-START

1° ARC FORCE 
1° PRE-GAS TIME 3 3 3 3 3 3 3 3 3 3 3 3
1° STARTING CURRENT            
1° SLOPE UP 4 4 4 4 4 4 4 4 4 4 4 4
1° SECOND CURRENT B-LEVEL   
1° BASE CURRENT        
1° PEAK TIME
       
1° PULSED CURRENT FREQUENCY 6 6 6 6 6 6 6 6
1° BASE TIME 5 5 5 5 5 5 5 5
1° DOWN SLOPE 4 4 4 4 4 4 4 4 4 4 4 4
1° FINAL CURRENT 4 4 4 4 4 4 4 4 4 4 4 4
1° POST GAS TIME            
2° VRD 
2° LONG ARC VOLTAGE 
2° REMOTE CONTROL ACTIVATION
            
2° SPOT TIG TIME   
2° HF ARC START            
2° MINIMUM PEDAL CURRENT 2 2 2 2 2 2
2° AC WAVEFORM
SPECIAL Q-START 3 3 3 3 3 3 3 3 3 3 3 3
SPECIAL DYNAMIC ARC       
SPECIAL MULTI TACK 3 3 3 3 3 3 3 3 3
SPECIAL MIX AC
SPECIAL FUSIONE EXTRA
SPECIAL AC FREQUENCY
SPECIAL AC BALANCE
SPECIAL ELECTRODE DIAMETER