Cloos GLC 353 MC3, Руководство по эксплуатации

Страница: 33 / 122

B-15
Welding
GLC 353/503/553 MC3
- Select the required Arc output by turning
Potentiometer 1 on the wire drive operation panel.
The resulting values for Wire feed speed and
Welding current set value can be read on
Display 1 and 2 on the power source.
- Begin welding.
Poti 1 Poti 2
Caution!
Protect eyes and skin against arc
radiation! Wear protective clothing !
- Turn Potentiometer 2 to adapt the Arc length to
the set arc output.
- Carry out test welds and optimize the settings on
Potentiometer 1 and 2.
- The actual weld parameters voltage and current are
shown on Display 1 - position Volt and on Display 2
- position Ampere.
Note: Set Display 1 on position mm. The display shows a plate thickness which can
be welded with the set arc capacity. This is only an approximate value which
has to be adapted during production !
If you select A
Hold
on Display 2 the maximum welding current used during
welding can be read at the end of the welding process.
B2.2 MIG-MAG Normal Synergic