55
11 DECOMMISSIONING
Disconnection
WARNING
Before performing any operation, read the warnings found in the
Maintenance chapter.
Avoid leak or spills into the environment.
Before disconnecting the unit, the following must be recovered, if present:
refrigerant gas
Anti-freeze solutions in the hydraulic circuit
Awaiting decommissioning and disposal, the unit can also be stored
outdoors, as bad weather and rapid changes in temperature do not harm
the environment provided that the electric, cooling and hydraulic circuits
of the unit are intact and closed.
WEEE INFORMATION
The manufacturer is registered on the EEE National Register, in compliance
with implementation of Directive 2012/19/EU and relevant national
regulations on waste electrical and electronic equipment.
This Directive requires electrical and electronic equipment to be disposed
of properly.
Equipment bearing the crossed-out wheelie bin mark must be disposed of
separately at the end of its life cycle to prevent damage to human health
and to the environment.
Electrical and electronic equipment must be disposed of together with all
of its parts.
To dispose of “household” electrical and electronic equipment, the
manufacturer recommends you contact an authorised dealer or an
authorised ecological area.
“Professional” electrical and electronic equipment must be disposed of by
authorised personnel through established waste disposal authorities around
the country.
In this regard, here is the definition of household WEEE and professional
WEEE:
WEEE from private households: WEEE originating from private households
and WEEE which comes from commercial, industrial, institutional and other
sources which, because of its nature and quantity, is similar to that from
private households. Subject to the nature and quantity, where the waste
from EEE was likely to have been by both a private household and users
of other than private households, it will be classed as private household
WEEE;
Professional WEEE: all WEEE which comes from users other than private
households.
This equipment may contain:
refrigerant gas, the entire contents of which must be recovered in suitable
containers by specialised personnel with the necessary qualifications;
lubrication oil contained in compressors and in the cooling circuit to
be collected;
mixtures with antifreeze in the water circuit, the contents of which are
to be collected;
mechanical and electrical parts to be separated and disposed of as
authorised.
When machine components to be replaced for maintenance purposes are
removed or when the entire unit reaches the end of its life and needs to
be removed from the installation, waste should be separated by its nature
and disposed of by authorised personnel at existing collection centres.
Содержание R513A
