CLIVET ELFOROOM 11, Руководство по установке и обслуживанию, Страница: 76 / 264

6 - CONTROL
Power on/off
To power on/off the adjustment unit, press and hold the OK key.
Off status is indicated on the display by the message OFF
Selection of mode of operation
If you press for about 3 seconds on the key

, the display will show the symbols that define current operating mode.
If you press key

you can select the desired operating mode in the following cyclical sequence
heating → economic heating → cooling → economic cooling → ventilation → heating
When you press the key [ OK ], you confirm the displayed mode. The symbols will flash during setting of the mode, and then normal
operation resumes.
During programming of the operating mode, if no key is pressed for about 10 seconds, you will go back to normal operation, without
modifying the operating mode.
Modification of adjustment set point
In normal operation, for operating modes that include it, you can modify the adjustment set point using the keys [  ] and [  ]
respectively to increase/decrease in steps of 0.1°.
Display of ambient temperature
You can display the ambient temperature as measured by the probe on the thermostat or the one on the unit. From normal operating
status:
press briefly on key

: the display will show the message Fan and the bar of the fans
press key

again: the display will show only the message tA .
press the key [ OK ] to confirm the selection. The message tA will flash on the display, followed by a return to normal operation in
which the message tA will alternate with the ambient temperature for a few seconds.
You can also go back to normal operation by pressing, instead of the key OK , the key

.Or you can wait about 10 seconds without
pressing any key.

selection of operating mode

increase selected field

decrease selected field
OK confirm set value / ON – OFF thermostat
Ventilation status Unit in COOLING mode ECO set point enabled
Active humidification Unit in HEATING mode
Unit automatically selects whether
to heat or cool
Compressor active
REMOTE
Management from ELFO
CONTROL
"Normal" operation, HID-TI connected to CLIVET-BUS:
•
the HID thermostat shows the operating status of the unit to which it is connected
•
periodically measure the temperature/humidity in the room where it is installed
•
it is possible to use only the 4 front keys (user programming).
"Nolink" operation, HID-TI not connected to CLIVET-BUS:
•
the thermostat is powered by auxiliary power (a battery must be present)
•
it is possible to access hidden keys for installer use
•
it is a temporary mode that allows "advanced programming" of the unit.
OPERATING MODES
6.7 HID-Ti2 THERMOSTAT - OPTIONAL
76