Climax FF5300, Руководство по эксплуатации

Страница: 53 / 86

P/N 91025, Rev. 4 Page 41
4 OPERATION
IN THIS CHAPTER:
4.1 P
RE
-
OPERATION CHECKS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -41
4.2 M
ACHINING
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -42
4.3 A
DJUSTING THE MACHINE WHEN THE CUT IS COMPLETED
- - - - - - - - - - - - - - - - - - - - - - - -43
4.4 D
ISASSEMBLY
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -44
4.1 P
RE
-
OPERATION CHECKS
Do not operate this machine without adequate training to fully understand safe
setup, operation, and maintenance.
WARNING
Rotating machinery can cause serious injuries. Turn off and lock out the
machine before making the pre-start checks.
The FF5300 often is used in dangerous locations (in elevated positions, near other
operating equipment, overhead, etc.). CLIMAX cannot foresee where this machine
will be used; therefore, you must perform a site-specific risk assessment
(Section 1.5 on page 4) for each job before starting work.
The FF5300 machine has remote operation features that enable you to choose the
optimum location to work from.
WARNING
Always follow safe work practices, including site-specific safety
requirements. It is your responsibility to perform a risk assessment
before you set up the machine and each time before you operate the
machine.
Do the following checks before operating the machine:
1. Complete the risk assessment checklist in Table 1-3 on page 5.
2. Check that all preventative maintenance is complete (Section 5) and the
drip rate is set correctly on the pneumatic conditioning unit (PCU). Refer to
Section 5.4.1 on page 49.
3. All energy supplies are off and the emergency reset button is released.
4. Check that the work area is clear of non-essential personnel and equipment.
5. Check that the machine control/observation area will not be in the path of
hot flying chips during machine operation.
6. Check the machine is securely mounted to the workpiece.