Climax FF5300, Руководство по эксплуатации

Страница: 46 / 86

Page 34 FF5300 Operating Manual
2. Mount a dial indicator or
other probe in the tool
holder (see Figure 3-17).
3. Adjust the four HHCS to
level the interface plate to
the chuck.
4. Adjust the jacking feet to
center the machine, if
required.
5. Once the machine is cen-
tered, tighten the jacking
screws to a minimum of 30
ft-lbs (40 Nm) to retain the
chuck.
WARNING
Failure to check that the chuck is secure could result in the machine
falling out of or into the workpiece, causing personnel injury or damage.
T
IP
:
Use the supplied 3/4" (19 mm) end wrench to hold the setup fingers
vertical while tightening the jacking screws.
6. Remove the setup fingers if necessary.
NOTICE
M6 screws are captive to the setup finger. Remove the setup fingers
only if they will interfere with the machining cut.
There are also additional M6 holes on the bottom of the jacking foot that
can be used to secure the machine in a vertical flange or overhead
mounting configuration.
3.11 R
OTATING THE TOOL HEAD
Do the following to rotate the tool head:
1. Loosen the swivel head locking screws on the front of the tool post (see
Figure 3-18).
F
IGURE
3-17. D
IAL INDICATOR MOUNTED