Climax FF5300, Руководство по эксплуатации

Страница: 34 / 86

Page 22 FF5300 Operating Manual
3.2 P
REPARING THE MACHINE FOR USE
3.2.1 Pre-setup check
The FF5300 can be set up and mounted in many ways. Before setting up the flange
facer, check the following:
• The machine assemblies are positioned correctly.
• There is enough room to position the entire machine on or near the
work piece.
• All connections are correctly attached.
3.2.2 Assessing the work area
The FF5300 often is used in dangerous locations (in elevated positions, near other
operating equipment, overhead, etc.). Climax cannot foresee where this machine
will be used; therefore, you must perform a site-specific risk assessment
(Section 1.5 on page 6 and Section 1.6 on page 7) for each job before starting
work.
The FF5300 machine has remote operation features that enable you to choose the
optimum location to operate the machine (Section 2.3 on page 21).
WARNING
Always follow safe work practices, including site-specific safety
requirements. It is your responsibility to perform a risk assessment
before you set up the machine and each time before you operate the
machine.
3.3 L
IFTING AND RIGGING
DANGER
The FF5300 can weigh 196.7 lbs (89 kg) when fully assembled in the
largest configuration.
Use caution and follow all site rigging procedures such as a lift plan and
never allowing anyone under the load. Falling or uncontrolled swinging
of machinery can cause serious injury or death.
The FF5300 has a single M12 lifting eye rated for 749lbs (340 kg).
CAUTION
Lift the machine only by the M12 lifting eye seen in Figure 3-1.