iGate
®
Connect Programmable Thermostat
R e v i s e d : D e c e m b e r 2 0 , 2 0 2 1
C l i m a t e M a s t e r Wa t e r-S o u rc e H e a t P u m p s
4
C L I M AT E M A S T E R WAT E R - S O U R C E H E AT P U M P S
TIP:
Wrap the wires around a pen or
pencil to keep them from falling inside
the wall.
4. Remove the current backplate.
5. Mount the new base.
a. Gently separate the display from the base of the
new thermostat by pulling thermostat straight
away from the base.
b. Position the base against the wall and determine
if wall anchors from current thermostat align with
screw locations of new base.
c. If base does not align with existing anchor holes,
mark new screw locations with a pencil.
• Drywall: Drill 3/16” hole for the anchor.
• Plaster: Drill 7/32” hole for the anchor.
d. Pull wires through opening in base and secure to
the wall using provided screws.
TIP:
Use a level to ensure thermostat
is properly aligned.
6. Connect wires.
a. Match your wire configuration to the terminals on
the base. Reference Diagram 1.
b. Connect each wire individually by pushing down
on the quick connect tab, inserting the wire into
the connector opening, and then releasing the tab.
c. If remote indoor and/or outdoor sensors are used,
they may be connected at this time.
TIP:
Use pliers to straighten wire before
inserting into new base. Be sure to cut any
excess wire so that the insulation extends
to the terminal block. When the wire is
installed properly to the terminal block,
there should be no copper exposed.
22 AWG shielded wire is required when installing a
remote sensor further than 100 ft (30.5 meters).
7. Attach the thermostat face.
a. Align the thermostat face using hinge guide on top.
b. Rotate the thermostat down until tab aligns with
hole in base.
c. Install security screw if necessary.
8. Return power to system.
Wiring Diagram
All excess wire should be pushed back into the wall as far
as possible.
A+
B-
C
R
S1
S2
Thermostat
Remote
Sensor
R
B-
C
A+
Unit Control
Diagram 1: Thermostat Connections
Thermostat Connections
A+ Communications (Positive)
B– Communications (Negative)
C 24V Common for Control Circuit
R 24V Supply for Control Circuit
S
1
Remote Sensor
S
2
Remote Sensor
SYSTEM CONFIGURATION
From the thermostat display:
1. To configure the System Settings using the myUplink
PRO mobile app, set the thermostat System Mode
to “OFF”.
2. Swipe left or right on the thermostat screen until you
reach the Fan screen.
3. Press the Fan button for 5 seconds to enable the
“System Settings” screen.
4. Scroll down to select the “AP Access” option.
5. Select “YES” to enable.
From the myUplink PRO app:
6. With your mobile device within 15 ft of the
thermostat, open and login to your myUplink
PRO app.
7. From the Systems screen, select the green “add”
button at the top right.
8. Select the “Connect Locally”. The app will find any
devices in Access Point mode.
