Clifford Intelliguard 850, Руководство по установке

Страница: 21 / 51

© 2004 directed electronics, inc.
19
type H: negative (-) multiplex
single-resistor type
If one resistor is used in the door lock switch/key cylinder, the wire will pulse ground
in one direction and resistance to ground when operated in the opposite direction.
two-resistor type
If two resistors are used in the factory door lock switch/key cylinder, the door lock
switch/key cylinder will read resistance to ground in both directions.
determining the proper resistor values
To determine the resistor values, the door lock switch/key cylinder must be isolated
from the factory door lock system. For testing, use a calibrated digital multimeter that
is set to ohms.
IIM MPPO ORRTTA AN NTT!! To ensure an accurate resistance reading, do not touch the resistor or
leads during testing.
1. Cut the output wire from the door lock switch/key cylinder in half.
2. Test with the meter from the switch side of the cut door lock switch/key cylinder
ON-BOARD
LOCK
RELAY
#87
#87A
#30
BCM
GREEN/BLACK
LOCK #30 COMMON (OUTPUT)
WHITE/BLACK
NOT USED
VIOLET/BLACK
LOCK #87 NORMALLY OPEN (INPUT)
BLUE/BLACK
UNLOCK #30 COMMON (OUTPUT)
VIOLET
UNLOCK #87 NORMALLY OPEN (INPUT)
15A
VEHICLE FUSED
+12 VOLT CONSTANT
LOCK RESISTOR
(IF REQUIRED)
UNLOCK RESISTOR
(IF REQUIRED)
DOOR LOCK SWITCH/
KEY CYLINDER
UNLOCK
(+)12V
CONSTANT FUSED
LOCK
DIA-629
BROWN/BLACK
NOT USED
H2/1
H2/2
H2/3
H2/4
H2/5
H2/6
ON-BOARD
LOCK
RELAY
#87
#87A
#30