Clifford Intelliguard 850, Руководство по установке

Страница: 11 / 51

© 2004 directed electronics, inc.
9
h2/10 brown/red brake light (+) 12V input
This is the polarity source for the brake light output and must be 12 volt constant.
h2/11 brown/white brake light output
This wire powers the brake light circuit with the 12 volt circuit only on H2/10
when activated.
h2/12 blue/white second unlock output (200mA)
This wire produces a (-) 200mA output for progressive locks in which the driver door
unlocks first and the remaining locks unlock with a second press of the unlock button.
immobilizer harness wire connection guide
immobilizer harness wiring
Locate the ignition and starter wires using a multimeter. Cut the appropriate wire and
attach the key side and car side wires to the corresponding wires on the four-pin
immobilizer harness.
ultrasecure immobilizer
The UltraSecure immobilizer circuit in this G5 system is a unique new design that
incorporates the immobilizer security of Clifford without the possibility of failure due
to power loss that could potentially strand the user.
The level of security can be set by leaving in or removing the jumper located next to
the immobilizer wires exiting the module.
H3/4 Ignition Car Side
H3/3 Ignition Key Side H3/2 Starter Key Side
H3/1 Starter Side
x
CUT
x
CUT
Starter
Ignition