Clevo W860CU, Руководство пользователя

Страница: 108 / 290

Upgrading The Computer
6 - 12 Upgrading the System Memory (RAM)
6
5. Gently pull the two release latches on the sides of the memory socket in the
direction indicated by the arrows (
&
)
in Figure 6 - 10 .
6. The RAM module will pop-up, and you can remove it.
7. Pull the latches to release the second module if necessary.
8. Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory slot.
9. The module’s pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the slot as it will go. DO NOT FORCE the module; it should fit
without much pressure.
10. Press the module in and down towards the mainboard until the slot levers click into
place to secure the module.
Figure 6 - 10
RAM Module
Removal
Single Memory
Module Installation
If your computer has a
single memory module,
then insert the module
into the
Channel 0
(JDIMM1) socket. In this
case this is the lower
memory socket (the
socket closest to the
mainboard).
14 15
16
14 15 16