123
REAR WHEEL/ SUSPENSION
Swing Arm Installation
Swing Arm Bearing Inspection
Wash the bearing parts in a low flash point solvent and dry.
Inspect the bearings for rust, pitting, broken rollers, or damage.
Inspect the bearing collar for excessive wear.
Inspect the dust seals for excessive wear or damage.
Damage or excessive wear will require part replacement.
Swing Arm Bearing Parts Identification
1.
Spacer Ø30 x Ø17 x 6
2.
Inner dust seal
Ø30 x Ø37 X 4
3.
Thrust washer
4.
Radial thrust bearing Ø34.5 x Ø22 x 6
5.
Needle bearing
Ø29 x Ø22 x 30
6.
Center collar
Ø22 x Ø15 x 54.5
7.
Outer dust seal
Ø29 x Ø21 X 4
1 2 3 4 3 5 6 7
1.
Clean the bearing bore and grease lightly to aid the
bearing installation.
2.
Press the
bearing
in to a depth of 6mm
±1mm.
Proceed slowly and wear gloves and eye protection
when using a hydraulic press.
