Installation Guide / SolarRoof Terracotta Tile
16
Code-Compliant Planning and Installation Guide V 1.0 - Complying with AS/NZS1170.2-2011 AMDT 2-2016
- Installation Instructions -
20mm
Step 4:
When using as an Inter Clamp, click the Universal Clamp into the
rail channel and slightly lift the framed PV Module to ensure the
Grounding Clip is fully covered as shown in the figure on the right.
Step 5:
Loosely place the next framed PV Module into the other side of
the Universal Clamp. Ensure the Grounding Clip is fully covered
and ensure the frame of the PV Module is in close contact with
Universal Clamp as shown in the figure on the right.
Step 6:
Repeat steps above to install all PV Modules. Visually check the
Universal Clamps and PV modules are properly positioned and
then fasten all Clamps.
When you are using Universal Clamps, the gap between two
adjacent PV Modules is 20mm. The recommend torque for
Universal Clamps in the End Clamp position is 13~14N·m. The
recommend torque for Universal Clamps in the Inter Clamp
position is 16~20N·m.
