MEDIPULSE 2342se ERGONOMIC SUCTION BLAST CABINET
Page 6
© 2019
CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 24939, Rev. C, 03/19
Figure 4
2.2.3
Install an isolation valve at the air source to
enable depressurization for service, and connect an air
line from the air source to the filter inlet located within
the power module.
WARNING
Hose disconnection while under pressure can
cause serious injury or death. Use safety lock
pins or safety wire to lock twist-on type air-hose
couplings together and prevent accidental
separation, and also use safety cables to prevent
hose from whipping should separation occur.
Safety lock pins and safety cables are listed in
Section 9.1: Optional Accessories.
2.3
Ground the Cabinet
2.3.1
To prevent static electricity buildup, attach an
external grounded wire from an earth ground to the
grounding lug on the left rear of the power module.
2.4
Connect Electrical Service
2.4.1
Standard MediPulse cabinets are 120-volt single
phase. Power is supplied by a U-ground plug; plug it into
a 120-volt outlet. No additional wiring is needed; the
wiring schematic shown in Figure 5 is for reference.
WARNING
Do not use electrical adaptors that eliminate the
ground prong on 120-volt plugs. Doing so can
cause electric shock and equipment damage.
Figure 5
1/2" NPT Air Filter
Use safety lock pins to secure
twist-on couplings.
Air-Supply Hose
Air Fitting
Use safety cable to prevent separated hose from whipping.
Once installed, all slack must be removed from the cable.
Plugged Auxiliary-Air Port
Apply thread sealant to male threads
.
120 VOLT, 1 PH CABINET WIRING
