CleaverBrooks Hawk 1000, Руководство по эксплуатации

Страница: 32 / 82

Section 4 — System Configuration Hawk 1000
4-2 Part No. 750-366
4.1 Introduction
The Hawk 1000 is equipped with a 4" color touch screen Human Machine Interface (HMI). The HMI along
with the Burner Control display are the points of interface for the operator to monitor and control the boiler,
and for the technician to configure and set up the system.
This section describes the HMI screens and their functions.
For information on the Burner Control (Flame Safeguard), refer to one of the following CB publications:
CB120E Burner Control 750-264
CB780E Burner Control 750-234
A gray button on the HMI indicates that a password is required before user input is allowed. The Hawk 1000
employs three levels of security: Operator, Service, and Factory. Pressing a gray pushbutton will display the
login entry window.
4.2 Main Menu
The Main Menu (Figure 4-2) is the first screen to appear when power is applied to the system. A header
section at the top of the screen shows the current date and time, the user login status, a logout button and
an alarm bell if an alarm is present. The rest of the screen consists of screen navigation buttons.
When the system is powered on for the first time
(Figure 4-3)
, the <System Config>* button will indicate “System
Config Required”. The screen will indicate “Commissioning Not Done” until initial configuration and commissioning have
been completed. Note also that some screen buttons will not yet be available.
*In this manual, screen buttons on the HMI are identified by the button description with arrows on either side (e. g. <Main>).
Figure 4-1. Firing Rate Screen