ClearView Panther-16HP, Быстрый старт

Страница: 11 / 270

6
Figure 1-3.
Figure 1-3
You can refer to the following sheet for alarm input and output information.
1
，
2
，
3
，
4
，
5
，
6
，
7
，
8
，
9
，
10
，
11
，
12
，
13
，
14
，
15
，
16
ALARM 1 to ALARM 16. The alarm becomes active in low voltage.
NO1 C1
，
NO2 C2
，
NO3 C3
，
There are three groups of normal open activation output (on/off
button)
Earth cable.
1.7.2 Alarm Input Port
Please refer to the following sheet for more information.

Normal open or Normal close type.

Please parallel connect COM end and GND end of the alarm detector (Provide external
power to the alarm detector).

Use the contro12V power to reset the smoke sensor remotely.

Please parallel connect the Ground of the DVR and the ground of the alarm detector.

Please connect the NC port of the alarm sensor to the DVR alarm input(ALARM)

Use the same ground with that of DVR if you use external power to the alarm device.
Figure 1-4
1.7.3 Alarm Output Port

Provide external power to external alarm device.

For contro12V, it can be used to provide power to devices such as reset smoke
sensor.

To avoid overloading, please read relay parameters sheet in the User
’
s Manual carefully.

RS485 A/B cable is for the A/B cable of the PTZ decoder.