13
CLEARSPAN
™
GARAGES
Revision date: 09.14.10
2. On the zippered end panel, insert the end conduit
through the two side panels of the end panel (as shown
below) and
not through the door sections
.
End Conduit
through Side
Panel
End Conduit
through Side
Panel
ATTACH END CONDUIT ASSEMBLIES
1. Using two (2) QH1330 angled brackets, secure one
(1) angled bracket to each end of the end conduit and
secure the conduit to the legs of the end rafter. See the
following diagram.
NOTE:
It may be necessary to cut the panel to attach
the bracket to the end panel conduit and to the end
rafter leg.
2. Repeat the steps for the remaining end panel.
3. Attach the end panels to the end rafters as described in
the next procedure.
3. Slide the remaining end conduit assembly into the hem
at the bottom of the solid (plain) end panel.
4. Continue with the next procedure.
End Conduit
End panel not
shown.
Angled Bracket
Tek screw
ATTACH END PANEL ASSEMBLIES
Gather the parts:
• End panel assemblies
• Tek screws (#FA4482B) and washers
• Measuring tape and scissors
Assembly Procedure:
1. While standing inside the shelter, start at the peak of
the end rafter and pull the solid (plain) end panel over
the top of the rafter so the panel edge is wrapped to the
inside of the rafter.
NOTE:
Use additional help to pull the end panel in
position over the entire rafter. It may be helpful to have
someone stand on the conduit to keep it on the ground
when stretching and attaching the end panel.
2. Move to the lower section of the rafter leg and end
panel on each side of the rafter, fold the end panel
material around the rafter tube, and secure it with
Tek screws and washers on the inside of the rafter
approximately 12" up from the conduit.
Attaching the end panel in this manner keeps the
lower section of the end panel in place as the panel is
stretched and secured to the rafter.
NOTE:
The screws are inserted on the backside or
inside surface of the rafter to prevent damage to the
main cover when it is installed.
3. Evenly space the screws and washers along the rafter
and pull the end panel tight as the screws are installed.
4. After securing the lower section of the end panel, move
to the top, stretch the panel to remove wrinkles, and
secure it in place as previously described.
12"
