CLEARSPAN
™
GARAGES
12
Revision date: 09.14.10
ANCHOR THE SHELTER
At this point in the assembly process, anchor the
assembled frame. Once the frame assembly is anchored
properly, continue with these instructions.
WARNING
: Securing the base rails to concrete blocks
or wood boards set on the site is not a substitute for
properly anchoring the shelter.
You must anchor the
shelter as described in the MUST READ document.
FAILING TO PROPERLY ANCHOR THE SHELTER
WILL RESULT IN DAMAGE TO THE SHELTER AND
MAY CAUSE PERSONAL INJURY.
READ THE MUST READ DOCUMENT TO PROPERLY
ANCHOR THE SHELTER.
The diagrams below illustrate two possible ways to properly
anchor the shelter to the site.
Install an anchor at each rafter leg along each side of the
frame.
The parts shown in the diagrams regarding anchor systems
are
not included
with the shelter.
Contact Customer Service
at 1-800-245-9881 to purchase additional parts to anchor
the shelter.
Anchor System
for use on concrete.
Ground Anchor System
END CONDUIT ASSEMBLY
Gather the parts:
• Pipe 1.315'' x 75'' swaged (#131S075)
• Pipe 1.315'' x 70'' plain (#131P070)
• Duct tape
• Tek screws
Complete the following steps:
1. Locate the end conduit pipes. Each end conduit
consists of one (1) 75" pipe and one (1) 70" pipe. Two
(2) end conduits are required.
2. Assemble an end conduit by connecting one (1)
swaged pipe and one (1) plain pipe.
3. Secure each joint using Tek screws and tape over the
Tek screws to protect the end panel.
NOTE:
Use duct tape to tape the Tek screws to prevent
damage to end panels.
4. Repeat assembly for the remaining end conduit.
PREPARE END PANELS
CAUTION:
To prevent damage, do not install end
panels on a windy day.
Gather the parts:
• End panel solid (plain)
• End panel 2-zip (zippered)
• End conduit assemblies (2)
• QH1330 Angled brackets
• Tek screws
Assembly Procedure:
1. Locate the end panels, unfold each panel at the base
of the assembled frame (where they will be installed)
with the inside surface facing up.
NOTE:
Verify that the long black straps are on the
inside, and the D-rings are on the outside.
