BarronettBlinds.com
BarronettBlinds.com
800-345-6007 • Fax (715) 822-4180
E-mail: [email protected]
Owner's Manual
Barronett Hub Blinds
Check for parts online at
www.barronettblinds.com
or call 800-345-6007 M-F 8-5 CST
We at Barronett Blinds appreciate your purchase of one of our world
class Hub Blinds. Follow these few simple instructions and your Hub
Blind will be sure to give you many years of trouble-free pleasure. In-
structions should be kept safe and reviewed at least annually.
If for any reason you have a problem with your product, DO NOT return
to the retailer; contact the Barronett Blinds customer service de-
partment at 800-345-6007, Monday through Friday from 8 a.m.
to 5 p.m., for assistance.
SET-UP InSTrUcTIonS:
1. Remove the ground blind from
backpack carrying bag.
2. Lay the blind flat on the ground
and be completely sure there is
no material twisted or overlap-
ping the ends of any poles.
SEE fIgUrE 1.
3. Grab the pull handle on the
eyelet located in the center of
the roof and pull upward so the
roof portion pops open. SEE
fIgUrE 2.
4. Lift the roof up so that you can
grab any one of the hubs located
in the center of each wall. Grab
the tie-down rope on the eyelet
and pull out as you did in step 3.
SEE fIgUrE 3.
NOTE: Place your foot on the
ground skirt to help hold the
blind in place when popping open
the walls. (Ground skirt is not
included in all models).
5. Proceed by walking around
entire blind and pulling on
each of the wall’s tie-down
ropes to pop out each wall
until all sides are popped out.
SEE fIgUrE 4 .
6. Your blind should be standing
up completely. You may now
proceed by anchoring the blind
to the ground using the ground
stakes and tie-down ropes pro-
vided. Ground stakes for your
Barronett Blind are located in a
pouch inside of the blind. The
pouch is sewn in at ground level
onto the interior wall near the
door. Anchor loops are sewn in
each corner and each side. Use
the provided tie-down ropes
and tie free end to ground stake.
SEE fIgUrE 5.
NOTE: Window configurations can now be set. Native brush
can be placed in brush holders located around the blind. (Brush
holders not included on all models.)
ASSEMBLY AND USE INSTRUCTIONS
FOR THE FOLLOWING MODELS:
SNAKE EYES (SE250BA, SE250BW, SE350BA, SE350BW)
GROUNDER (GR150BT, GR250BT, GR350BT)
BIG MIKE (BM275BT)
warning
rEAD, UnDErSTAnD AnD folloW All ASSEMBlY,
InSPEcTIon, AnD USE InSTrUcTIonS ProVIDED
BEforE EAcH USE. fAIlUrE To folloW WArn-
IngS AnD InSTrUcTIonS coUlD rESUlT In SErI-
oUS InJUrY or DEATH.
KnoW THE locATIon of EAcH HUnTEr In YoUr
PArTY AT All TIMES AnD BE AWArE of AnY
onE ElSE HUnTIng In THE ArEA To AVoID Ac-
cIDEnTS.
USE cAUTIon WHEn SETTIng UP. KEEP AWAY
froM BoDY AnD fAcE. KEEP clEAr of oTHEr
PEoPlE WHIlE SETTIng UP.
THIS ProDUcT IS noT fIrEProof. THE fABrIc
WIll BUrn If IT coMES InTo conTAcT WITH An
oPEn flAME or fUEl SoUrcE. no HEATEr or
oPEn flAME SHoUlD BE USED InSIDE or nEAr
THIS BlInD.
nEVEr AlloW cHIlDrEn or ADUlTS To USE
lIgHTED cAnDlES, MATcHES, or oTHEr SoUrc-
ES of fIrE nEAr THIS ProDUcT.
nEVEr USE AnY DEVIcES THAT ProDUcE fUMES
WHIlE InSIDE of BlInD. SUcH DEVIcES coUlD
rESUlT In cArBon MonoXIDE PoISonIng, In-
JUrY, or DEATH.
WHEn gUn HUnTIng, YoU SHoUlD AlWAYS AT-
TAcH THE BlAZE orAngE SAfETY cAP (noT In-
clUDED) PArT no. AV180 To THE roof of BlInD
for ADDED SAfETY froM oTHEr HUnTErS.
uv warning
UlTrAVIolET lIgHT BrEAKS DoWn lIgHTWEIgHT fAB-
rIc fIBErS. THE MATErIAl WIll fADE, loSE STrEngTH
AnD EVEnTUAllY DISInTEgrATE If lEfT In ProlongED
SUnlIgHT. To EXTEnD THE lIfE of YoUr groUnD
BlInD, AVoID lEAVIng IT oUT In DIrEcT SUnlIgHT for
EXTEnDED PErIoDS of TIME. SET IT UP In A SHADY ArEA
WHEnEVEr PoSSIBlE. fADIng or DIScolorIng of
BlInD IS noT coVErED UnDEr YoUr WArrAnTY.
OMHUBS
Rev. 04/05/10
© 2010 Ardisam, Inc.
All Rights Reserved.
FIGURE 1
ROOF
FIGURE 2
ROOF
FIGURE 3
ROOF
W
ALL
FIGURE 4
FIGURE 5
