CLEARSPAN
™
GARAGES
14
Revision date: 09.14.10
ATTACH END PANEL ASSEMBLIES (continued)
INSTALL SIDE RATCHETS
The main cover is secured to the shelter frame using
ratchets and straps. Two (2) ratchets are attached to each
of the end panel conduits. The remaining ratchets are
evenly spaced long each side of the shelter and directly
across from each other on the
same rafter assembly
.
5. Continue attaching the end panel by working evenly
down both sides of the rafter toward the base frame
tube.
NOTE:
If necessary, remove the Tek screws at the
bottom of each rafter leg to work wrinkles out of the
end panel and reinstall the Tek screws.
6. After installing the first end panel, repeat the steps to
attach the remaining end panel.
NOTE:
The excess end panel material can be
removed, or folded under and attached to the rafter
as described earlier. If the excess is removed, allow at
least six inches (6") to remain beyond the Tek screws. If
the panel is removed for any reason, the extra material
is used to pull the panel tight.
7. After installing both end panels, install the ratchets.
Ratchets are attached to the outside of the base frame tube
and to the
end panel conduit
as shown above.
Complete these steps to attach the ratchets to the frame:
1. Locate the ratchets (QH1061) and Tek screws
(FA4482B) used to attach the ratchets to the frame
tube.
2. Move to the outside of the first
end rafter
and attach
one (1) ratchet to the frame tube as shown below.
Ratchets
