Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • [email protected]
12
YOURx-Aerial Terminal
Installation Manual
_________________________________________________________
Manual 019588 REV B - Sept 2018
On the outside of terminal, at the desired port, insert the FlexPort pieces as shown.
Installing FlexPorts in the Field
Clip
Press-In
O-Ring
Step 1:
Insert an O-ring into the desired port. Push the O-ring all the way into the
port, as far back as it will go. Make sure it lies flat in the port.
Step 2:
Insert the “Press-In” piece into the port after the O-ring. Be sure to place the Press-In into the port tapered side first,
with the teeth side facing outwards. Press hard or
gently
tap it into place with a tool, as needed, until it sits fully flush.
Step 3:
Install the “Clip” piece of the FlexPort into the Press-In. It should click into place. Once installed, Clips should be
loose, not springy. If you notice the Clip being pushed out, re-adjust the O-ring.
