35
FieldSmart
®
Fiber Distribution Hub (FDH)
__________________________________________________________
Installation Manual
Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • [email protected]
Manual 019703 REV B - March 2019
288 & 576 Port FDH
Single Staging Plate
Two Staging Plates
Note:
The diagram shown represents the 288 FDH and the left half of the 576. Simply mirror the process for
the right side of the 576 FDH.
If you intend to place two staging plates into the cabinet at one
time, replace the foam cradle with the foam strips as shown by
the install manual provided with the splitter.
Install the splitter body into the top-most usable slot in the split
-
ter cage, to minimize fiber crossing, and lock into place using
the splitter retainer pin.
Route the splitter up and around the management spools and
to the staging area. Clearfield recommends following the routing
diagram shown here.
Install the staging plate(s) into the staging area, as shown in the
pictures below and the install manual provided with the splitter.
Proceed to connecting the feeder and distribution legs of the
splitter as needed. Choose your desired port to connect the
splitter leg. Clearfield recommends you reference the routing
diagram and designation card shown here and in the cabinet.
Each port will have a color corresponding to the radius spool
that the splitter leg must route over to properly take up the slack
before connection.
Record the splitter leg number on the designation card in the correct cell.
1.
2.
3.
4.
5.
6.