Clear-Com Tempest2400, Справочное руководство

Страница: 30 / 102

22 www.clearcom.com
BaseStation Headset Connection and Controls
The BaseStation headset connection is a functional user communication point, and may also be used for setup and
troubleshooting. The Front Panel Headset can communicate on any one of the two intercom channels. Controls for this
headset are located just to the right of the connector, and in the menu on the BaseStation Settings screen.
The front panel headset connector is a 4-PIN XLR male. A compatible headset must be provided by the user.
The TALK button enables or disables the microphone for the local headset. A blue LED will backlight the word “TALK” on
the TALK button when the mic is enabled. Always keep the microphone disabled (TALK off) when not is use.
Tempest uses an intelligent latching method for TALK buttons. Pressing the TALK button momentarily (less than two
seconds) will latch the mic button. The blue “TALK” LED will remain lit and the microphone will remain enabled. Pushing
and holding the TALK button for more than two seconds will cause the button to act in a momentary or push-to-talk
fashion, so the blue “TALK” LED will remain lit and the microphone will remain enabled only as long as the button is
pressed.
In Operational Mode turning the Volume control adjusts the volume of the audio of the local headset. Turning the
Volume control clockwise increases the audio level while turning the control counter clockwise decreases the level. The
Volume control knob is also a push button. Pressing the Volume control cycles the Channel selection and LEDs in order
from A to B.
The two Peak LEDs indicate when the mic audio from the local headset is reaching a peak level and is about to enter into
limiting. These LEDs should normally be off.
Set the Mic Gain for the Local Headset
Set the Mic Gain properly to assure the best audio quality. To set the Mic Gain for the Local Headset:
1. Press MENU to enter Menu Mode.
2. From the Main Menu select “BaseStation Settings,” then “Set Mic Gain.”
3. While at the “Set Mic Gain” screen talk into the local headset microphone in a louder than normal level and adjust the
Volume control until the Peak LED for the selected channel just starts to light at the loudest parts of the audio. Press ENT to
accept the changes.
When the Mic Gain is set too high it is possible to induce feedback or echo. When set too low, words can be clipped by
the low level noise gate, or may sound too quiet to other listeners. Headsets by different manufacturer’s or different
models of headsets will require widely varying Mic Gain settings. When setting microphone gain it is best to err toward
a setting that is too low, rather than too high. This will help reduce unwanted echo in the system when that microphone
is enabled.