6
DWS - Series | Version 1.03
Safety
- Never use the power cord to move or lift the spe-
cial house water system.
- Do not bend, crush, pull or drive over power cords
and extension cords.
- Disruptions that affect safety are eliminated imme-
diately.
- Before using the House water system make sure
that no parts are damaged. Replace damaged
parts immediately to avoid sources of danger!
- Never overload the house water system! Working
within the stated performance limits is better and
safer.
- Do not expose the pump to rain.
- Do not use the pump in hazardous areas or near
flammable liquids and gases.
- Do not touch the power plug with wet hands.
- Seal all fittings with a thread sealing tape to pre-
vent leakage.
- Do not let the pump run dry for a long time.
- Only touch the pump if it has been switched off for
at least 5 minutes.
- Only dismantle the pump body with the pump
switched off and the pump chamber empty.
- Only use original spare parts and accessories to
avoid possible dangers and accident risks.
- Should it be necessary to work next to the ma-
chine, the use of ear protection (headphones, ear-
muffs, etc.) is required.
ATTENTION!
If the ambient temperature is lower than 4 ° C or the
pump is not used for a long time, drain the piping
system to prevent ice from forming in the pump
chamber.
ATTENTION!
Place the cable so that it can not be sucked into the
pump.
ATTENTION!
Store the device taking into account its weight, viz.
on a firm, level surface and only in a closed room
without moisture.
ATTENTION!
The pumped liquid can be hot and under high pres-
sure. Before moving or dismantling, drain the fluids in
the pump and piping to prevent scalding.
ATTENTION!
The water pump is not used for drinking water sup-
ply or for pumping food.
ATTENTION!
Do not pump salt water with the pump!
ATTENTION!
After the device has been tipped over, it is recom-
mended to set it up again and then switch it off.
ATTENTION!
Check that the supply voltage of the water pump
matches the technical data label of the water pump.
Failure to comply with these rules may result in fire,
personal injury or even death.
ATTENTION!
The pump is not suitable for pumping salt water, fae-
ces, flammable, corrosive, explosive or other haz-
ardous liquids. The delivery fluid must not exceed or
fall short of the maximum or minimum temperature
specified in the technical data.
ATTENTION!
When pumping contaminated liquids, install a suc-
tion strainer to protect the pump from dirt.
ATTENTION!
If water is not pumped after operating the water
pump for 5 minutes, switch off the pump, fill with
water and check for leaks.
