6
GP - Series | Version 1.03
Safety
- Eliminate disturbances that affect safety immediately.
- Before each use, make sure that no parts are damaged
on the water pump.Damaged parts must be replaced
immediately to avoid danger sources.
- Do not overload the water pump! You work better and
safer in the specified performance range.
- Do not expose the pump to rain.
- Do not use the pump in hazardous areas or near flam
-
mable liquids and gases.
- Do not touch the power plug with wet hands.
- Seal all screw connections with a thread sealing tape to
prevent leakage.
- Do not allow the pump to run dry for a long time
- Only touch the pump if it has been switched off for at
least 5 minutes.
- Only dismantle the pump body with the pump switched
off and the pump chamber empty.
- Avoid splashing water on the electric pump and do not
immerse it in water.
- Only use original spare parts and accessories to avoid
possible risks and risks of accidents
- Should it be necessary to work next to the machine, the
use of ear protection (headphones,Earmuffs, etc.) re
-
quired.
.
ATTENTION!
If the ambient temperature is lower than 4 ° C or the
pump is not used for a long time, drain the piping
system to prevent ice from forming in the pump
chamber.
ATTENTION!
Store the device taking into account its weight, viz.
on a firm, level surface and only in a closed room
without moisture.
ATTENTION!
The pumped liquid can be hot and under high pres-
sure. Before moving or dismantling, drain the fluids in
the pump and piping to prevent scalding.
ATTENTION!
The water pump is not used for drinking water sup-
ply or for pumping food.
ATTENTION!
Do not pump salt water with the pump!
ATTENTION!
After the device has been tipped over, it is recom-
mended to set it up again and then switch it off.
ATTENTION!
Check that the supply voltage of the water pump
matches the technical data label of the water pump.
Failure to comply with these rules may result in fire,
personal injury or even death.
ATTENTION!
The pump is not suitable for pumping salt water, fae-
ces, flammable, corrosive, explosive or other haz-
ardous liquids. The delivery fluid must not exceed or
fall short of the maximum or minimum temperature
specified in the technical data.
ATTENTION!
When pumping contaminated liquids, install a suc-
tion strainer to protect the pump from dirt.
ATTENTION!
If water is not pumped after operating the water
pump for 5 minutes, switch off the pump, fill with
water and check for leaks.