Cleanco Compact 45, Руководство пользователя

Страница: 24 / 84

23
ENGINE COOLANT REPLACEMENT
Annually the coolant in the Vehicle Engine should
be replaced. This coolant is an integral part of the
heating system and needs to be maintained as any
other working part of the system. We recommend
that this procedure be accomplished by the
following steps.
DRAINING COOLANT:
1.
Remove one end of Heater core “Y”. Open
Heat Exchanger Petcock’s.
NOTE: Be sure that used coolant is
collected in a proper container and
disposed of in accordance with local laws.
REPLACING COOLANT :
See your authorized Cleanco service center, as
special procedures and tools are required.
WATER PUMP DRIVE BELT
To tighten the water pump belt:
1. Loosen the nuts which hold the water pump
mount to base.
2. Adjust the position of the belt tension adjusting
bolt until the proper belt tension is achieved.
(1/2” deflection in the center of the belt,
halfway between the pulleys).
3. While checking the alignment, tighten the nuts
which hold the water pump mount to base.
WASTE TANK LINT BASKET
The lint basket located inside the waste tank
should be removed and cleaned whenever it is full
of debris. This should be done at the end of each
job.
WASTE TANK FLOAT VALVE
The float valve in the waste tank shuts the unit
down once the waste tank becomes full. Check
the float valve for debris at least once a month.
INLINE WATER FILTER
The filter is located on the inlet plumbing assembly
of the pump. Clean this filter once a week.